For mounting of stair treads, roof plates, roof tiles, frame works, skirting boards, thresholds, laths (wood / plastic), paneling, window sills, sheet material, drywall, tiles, insulation material, soft and hardboard boards, electrical boxes, nameplates, house numbers, brackets and decorative ornaments and moldings of plaster, polyurethane- and polystyrene foam (Styrofoam) etc. Also suitable for mirrors and natural stone.

Not suitable for PE, PP, PTFE and bitumen. When gluing plastics always perform an adhesion test first. Adhesion to plastics can vary depending on the type of synthetic and the quality of the plastic.

Use Power Pistol to apply adhesive. Knife or Bison Multi Tool to open the cartridge. If necessary, use a rubber mallet to tap surface lightly.

Before using open cartridge at the top by cutting off the plastic nipple above the thread with a sharp knife. Fix the nozzle onto the cartridge and cut at an angle to the desired diameter.

Cut the nozzle open at a diameter of atleast 0.5cm

The surfaces to be glued must be clean, dry and free of grease and dust. Remove loose debris. Apply the adhesive in dots or stripes (at a distance of 20 - 30 cm), always taking care to apply at all angles and on the edges. Attach the object with a sliding movement, pressing it well. Hand-tight after approx. 30 minutes (the bond is now sufficiently strong for transport or light loads). Can be loaded after approx. 4 hours, depending on the substrate and the ambient conditions.

The drying times are based on bonding at least one porous material and an adhesive layer of approx. 1 mm thickness. If two non-porous materials are being bonded and/or the layer of adhesive is thicker, the drying times may be substantially longer.

Use white spirit for cleaning tools and removing wet adhesive residue. Dry adhesive residue can only be removed mechanically.

Close container properly and store in a dry, cool and frost-freeplace.